UPS ENERTRONIC P

Industrial UPS System with three phase output 60 - 120 kVA

Static UPS’s are being installed increasingly for loads that require AC voltages unaffected by interference on the mains e.g.:

• Data processing installations
• Process control computers
• Air safety installations
• Signalling, alarm systems
• Telecommunication systems
• Power- and Substations

Design

Due to the use of IGBT transistors of the newest technology in the rectifier and in the inverter, the new ENERTRONIC P range fulfills the highest reliabilty for power supplies and is very economical.
This results in an input power factor of ≥ 0,99 and an input distortion factor of < 5 %.
The exceptional characteristics of this inverter in the ENERTRONIC P series results in very small dynamic voltage deviations even in the case of one hundred percent load changes.
A combination of a 16-bit micro-controller and the latest power electronics is responsible for controlling and monitoring of all rectifier, inverter and static switch functions with highest reliability. A static switch and a manual bypass switch are integrated in the unit.
In the front of the cabinet there is a plastic foil keyboard with 6 keys, 4 three coloured and 2 single coloured LED’s and a mimic diagram.

Characteristics

• input power factor of ≥ 0.99
• input distortion factor of < 5 %
• meet the highest UPS classification VFI SS 111 in accordance with EN 62040-2
• power factor = 1
• high efficiency in the partial load range /li>
• low distortion factor at non linear load
• up to eight units can be connected parallel, operating in an active load-share
• proofed and convenient remote management
• with three phase input and three phase output
• UPS Nominal output power (cos. ϕ=0,8 ind.): 60 kVA, 80 kVA, 120 kVA